Eemil
Piispanen.

Most of what I make starts on a soldering mat and ends up in a field.
I'm Eemil, a builder from Finland. I design and build large unmanned aircraft from scratch: the structure, the wiring, the power system and the code. The workshop is a barn, the runway is a gravel road, and the test range is whatever has just been harvested.
I like owning the whole problem. Draw it, build it, fly it, find out what was wrong with it, and start on the next one.
- FocusUnmanned aircraft, electronics, software
- ToolsCAD, a soldering iron, a laptop and a lot of tape
- LocationFinland
From the bench to the field.

The bench
Battery packs, flight electronics and Kapton tape. Everything gets powered up here before it goes near an airframe.

Assembly
Wiring the airframe on the barn floor. Motors out on the wings, everything else down the spine.

Ground tests
Laptop on a stool, controller in hand. Motor checks and tuning until nothing surprising happens.

Rollout
Dawn, fog on the fields. The tow vehicle is a tractor.

Field repairs
Every flight day ends with a list. Some of it gets fixed on the spot, with tape.
Be delusional.
Then do the work until it isn't.

